Last updated: November 2026.
This guide covers Jacuzzi and Sundance hot tubs, Jacuzzi swim spas. Your model’s owner’s manual takes priority. Questions about your hot tub? Send Arctic Home a service inquiry.
Short answer: a Jacuzzi or Sundance hot tub that is powered and working properly is designed to protect itself from freezing. The risk rises when power is interrupted or the tub sits unused in severe cold. In those cases we recommend removing all water from the spa and equipment, and you can contact us at any point with questions.
Yes. Jacuzzi and Sundance spas are designed to protect themselves against freezing when they are operating properly. During severe cold, we recommend checking from time to time that power to the spa has not been interrupted.
When temperatures drop below 32°F (0°C), adjust your settings for your model. Here is what we recommend for each model family:
|
Model family |
What we recommend below 32°F (0°C) |
Reference |
|---|---|---|
|
Jacuzzi J-200 (2026) |
Program filtration cycles to run a minimum of 8 hours per day. |
2026 J-200 Owner’s Manual (PDF), 12.7 Winterizing |
|
Jacuzzi J-300 |
Program the primary filtration cycle to run 24 hours. |
Jacuzzi manuals, J-300 Owner’s Manual, Winterizing |
|
Jacuzzi J-400 |
Set the pump for 24-hour operation and select auto-heating. |
J-400 Collection Owner’s Manual (PDF), 13.8 Winterizing |
|
Jacuzzi J4 (2026) |
Choose the 24-hour Mode Cycle and auto-heating. |
2026 J4 Owner’s Manual (PDF), 12.9 Winterizing |
|
Jacuzzi J5 |
Set the circulation pump to 24-hour operation and make sure auto heating is selected. |
J5 Owner’s Manual (PDF), Winterizing |
|
Jacuzzi swim spas (2026) |
Set the circulation pump to 24-hour operation and select auto-heating. |
2026 Swim Spa Collection Owner’s Manual (PDF), 13.9 Winterizing |
|
Sundance 780 Series |
Program the primary filtration cycle to run for 24 hours. |
Sundance manuals, 780 Series Owner’s Manual, Winterizing |
|
Sundance 880 Series |
Program the circulation pump to run 24 hours. |
Sundance manuals, 880 Series Owner’s Manual, Programming the Primary Filter and Winterizing |
Not sure which model you own, or how to change these settings? Send us a service inquiry with your brand and model.
If the outage is prolonged during severe cold, we recommend removing all water from the spa and equipment to protect it from freeze damage. We do not set an hour count for “prolonged.” If power is out and you are unsure what to do, at any duration, contact Arctic Home service and we will help you decide.
We also recommend expert winterization for any drain. If you drain the tub yourself, follow the steps below and your own manual. J5 owners should know that the J5 manual states damage from freezing is not covered under the manufacturer’s warranty.
-
Keep it running when power is on and the spa is operating properly, using the cold weather settings in the table above.
-
Drain it when you do not plan to use the spa, or when a prolonged power outage hits during severe cold.
These steps can minimize damage in an emergency. They come from the Jacuzzi J-200, J4, and J5 manuals and the Sundance 880 manual. J-300, J-400, 780, and swim spa owners should follow the Winterizing section of their own manual. We recommend expert winterization whenever possible.
Turn off power to the hot tub first.
-
Drain the spa using the draining directions in your manual.
-
J4, J5, and Sundance 880 only: turn the massage/diverter selector(s) to the middle combo position and open the waterfall valve(s) so water in the plumbing lines can drain.
-
As the water level drops below the seats, move the water out of the recessed seating areas into the footwell, for example with a wet/dry vacuum.
-
Open all air controls and leave them open until you resume use.
-
J-200 and Sundance 880: remove the cabinet panel, find the drain plugs on the front of the pump(s), and remove them to let water drain from the pumps and heater. Expect about 1 to 2 gallons. Use a wet/dry vacuum or other means so the equipment compartment does not flood, then replace the plugs.
-
J-200 and Sundance 880: loosen the hose clamp at the bottom of the ClearRay unit, pull the hose off the fitting, tip it down to drain, then reinstall the hose and clamp. Remove and store the UV bulb in a safe place, dry the quartz tube, and reinstall it. Depending on how long the spa will sit, consider replacing the UV bulb when you resume use.
-
Reinstall the cabinet panels and cover the spa so no moisture can enter.
For J4 and J5, follow the remaining steps in your manual’s Winterizing section.
Reference: 2026 J-200 manual (PDF), 2026 J4 manual (PDF), J5 manual (PDF), and the Sundance manuals (880 Series), Winterizing sections. Questions on any step? Send a service inquiry.
Be careful. Water left in sections of the piping may still be frozen after a spa sits empty in freezing temperatures. That ice can block water flow, keep the spa from operating properly, and possibly damage the equipment. We recommend contacting Arctic Home service before you try to restart it.
In Alaska winters, the Kodiak cold plunge must be installed indoors. It is not for outdoor use during the winter.
The same cold-weather habits apply. During severe cold, we recommend checking from time to time that power to the Kodiak has not been interrupted. Below 32°F (0°C), set a warmer temperature. If you do not plan to use the Kodiak, or if power is out for a prolonged period in severe cold, remove all water from the Kodiak and the heat pump. The Kodiak manual states that damage from improper winterization is not covered under the Limited Warranty, and that a Kodiak that is not winterized and freezes will void the warranty. We recommend having a licensed professional winterize it.
Reference: Kodiak Cold Plunge Owner’s Manual (PDF), Winterizing section.
Send Arctic Home a service inquiry with your hot tub brand and model and tell us what is happening. Related read: Spa Dragon, Your Hot Tub’s Best Friend.
Manuals referenced
-
Jacuzzi manuals and user guides (J-300)
-
Sundance manuals and user guides (780 Series, 880 Series)
